Yamaha Snoscoot 80 Fuel Primer Kits

We offer fuel primer kits for the classic Sno-scoot 80. As the factory "choke" feature on the original Scoot is actually a fuel enricher circuit, and the stock choke plunger has been discontinued (part number 5V7-14171-00-00), this is your cold-start solution. Our kit comes with everything needed to install the kit, which is pictured to the left (include "choke plunger" block-off plug not shown) and works especially well when it's very cold. This kit fits all 1988-1990 Yamaha Sno-scoot 80 models.

INSTALLATION INSTRUCTIONS:

To install the kit, remove your choke cable and plunger in the carburetor, and insert our choke block-off plug, screwing the cap on snugly to seal off the chamber. Next install the included T-fitting in line just before the fuel pump, install the primer pump in the dash panel where the choke cable mounted, and install the included machined spacer plate between the intake boot and reed cage with the included gaskets and bolts. Connect the T-fitting to the "fuel- in" port on the pump (labeled on the diagram below), and then the "fuel out" port to the pre-installed fitting on the aluminum spacer plate and you're ready to go! It's that simple!